Figure 2 | Scientific Reports

Figure 2

From: Modelling and manufacturing of 3D-printed, patient-specific, and anthropomorphic gastric phantoms: a pilot study

Figure 2

The mechanical properties of specimens with various hardness degrees and numbers of silicone coatings. Four different composites of the Agilus with Vero (A-V) were printed to control for hardness value of 30, 40, 50, 60 Shore A (A): tensile strength [MPa]; (B): elongation [%]). The mechanical properties are presented according to the number of coatings for all three materials (C): tensile strength [MPa]; (D): elongation [%]). The plots were drawn using R packages dplyr and ggplot2.

Back to article page