Correction to: Scientific Reports https://doi.org/10.1038/s41598-024-82930-6, published online 09 January 2025
The original version of this Article contained citation errors.
As a result, in the Introduction
“Wu et al.17 studied the mechanism of filling body control over the movement of the overburden and found that the filling rate and steps are key factors in preventing roof failure.”
now reads:
“Wu et al.23 studied the mechanism of filling body control over the movement of the overburden and found that the filling rate and steps are key factors in preventing roof failure.”
And
“Building on this, Chen et al.23 examined the spatial structural changes of overburden under three-sided goaf conditions in the Daizhuang Coal Mine with strip filling.”
now reads:
“Building on this, Chen et al.34 examined the spatial structural changes of overburden under three-sided goaf conditions in the Daizhuang Coal Mine with strip filling.”
In addition, in the ‘Overburden movement characteristics under composite structural support’ section, under the subheading ‘Stress distribution patterns of overburden at different advancing distances’.
“As shown in Fig. 23, within the range of 60 m to 80 m from the model boundary, the supporting stress in the mined-out area reaches up to 3.7 MPa, indicating that the fragmented rocks in the mined-out area have begun to experience compaction.”
now reads,
“As shown in Fig. 25, within the range of 60 m to 80 m from the model boundary, the supporting stress in the mined-out area reaches up to 3.7 MPa, indicating that the fragmented rocks in the mined-out area have begun to experience compaction.”
Furthermore, in the Reference list
Reference 18
“Guo, G., Wang, G. & Ma, Z. A new method for ground subsidence control in coal mining. J. China Univ. Min. Technol. 02, 26–29 (2004).”
now reads:
Reference 18
“Guo, G., Wang, Y. & Ma, Z. A new method for ground subsidence control in coal mining. J. China Univ. Min. Technol. 02, 26–29 (2004).”
Finally, the authors omitted the below Reference, which is listed below as Reference 34.
“Chen, S., Guo, W., Zhou, H. & Wen, G. Structure model and movement law of overburden during strip pillar mining backfill with cream body. J. China Coal Soc. 36(07): 1081–1086 (2011).”
The original Article has been corrected.
Author information
Authors and Affiliations
Corresponding author
Rights and permissions
Open Access This article is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License, which permits any non-commercial use, sharing, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if you modified the licensed material. You do not have permission under this licence to share adapted material derived from this article or parts of it. The images or other third party material in this article are included in the article’s Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article’s Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by-nc-nd/4.0/.
About this article
Cite this article
Huang, L., Guan, W., Guan, Y. et al. Author Correction: Overburden movement law in strip filling mining of upward mining faces. Sci Rep 15, 8298 (2025). https://doi.org/10.1038/s41598-025-92899-5
Published:
Version of record:
DOI: https://doi.org/10.1038/s41598-025-92899-5