Abstract
Ni/Cu–P composite coatings were fabricated on Q235 steel substrates with dimensions of 20 mm×15 mm×2 mm by introducing different CuSO4 concentrations (0–0.30 g/L) into the Ni–P plating bath, denoted as SCU-0, SCU-0.1, SCU-0.15, SCU-0.2, and SCU-0.3, respectively. The effects of Cu addition on the structural, mechanical, magnetic, and corrosion properties were systematically investigated. The SCU-0.15 coating, deposited with 0.15 g/L CuSO₄, exhibited the most compact microstructure with a Cu content of 1.28 wt% and a thickness of 68.7 μm. TEM analysis confirmed that amorphous phosphorus was uniformly distributed in the Ni/Cu solid-solution matrix, forming nanosized grains (~ 34.6 nm) that improved structural uniformity. Compared with the undoped Ni–P coating (447.6 HV), the SCU-0.15 coating showed a markedly enhanced hardness of 713.5 HV and the lowest wear loss. The saturation magnetization decreased from 443 to 284 emu/cc as the CuSO₄ concentration increased from 0.1 to 0.3 g/L. Electrochemical testing in 15 wt% HNO₃ revealed that the SCU-0.15 coating possessed the most positive corrosion potential and the lowest corrosion current density (30.79 µA/cm²). Its charge-transfer resistance reached 4678.4 Ω·cm², and the largest Nyquist arc radius further confirmed superior corrosion protection. Overall, moderate Cu incorporation refined grains, strengthened the Ni–P matrix, and significantly improved the hardness, wear resistance, and corrosion durability of the coatings, demonstrating an effective route to optimize Ni-P coating performance.
Data availability
Data are contained within the article.
References
Jia, Y. et al. Tribological behaviors of electroless nickel-boron coating on titanium alloy surface. Chin. J. Mech. Eng. 37 (1), 309–320 (2024).
Chowdhury, T. A. XPS studies on electroless as-deposited and annealed Ni-P films. Engineering 16 (5), 123–133 (2024).
Chen, W. X. et al. Tribological properties of Ni-P-multi-walled carbon nanotubes electroless composite coating. Mater. Lett. 57 (7), 1256–1260 (2003).
Meng, Z. X., Shi, Y. H., Qiao, Z. L., Yang, J. Y. & Wang, L. Study on microstructure and corrosion resistance of Ti-doped nickel-based alloy coatings. J. Solid State Electrochem. 26 (8), 1677–1686 (2022).
Dong, G., Yan, B. A., Deng, Q. L. & Yu, T. Effect of niobium on the microstructure and wear resistance of nickel-based alloy coating by laser cladding. Rare Metal Mater. Eng. 40 (6), 973–977 (2011).
Rabizadeh, T. & Allahkaram, S. R. Corrosion resistance enhancement of Ni-P electroless coatings by incorporation of nano-SiO2 particles. Mater. Design. 32 (1), 133–138 (2011).
Bhattacharyya, S., Kumar, P., Choudhary, D., Pal, S. K. & Chakraborty, S. Development of electroless Ni-P-Cu composite coating: A characterisation, corrosion and thermal study on AISI-1040 used in heat exchangers. JOM 76 (11), 6600–6614 (2024).
Ma, Z., Jiang, B., Drummer, D. & Zhang, L. Influence of phosphorous acid concentration on the self-lubricating properties of electroformed Ni-P-PTFE ternary composites. Surf. Coat. Technol. 477, 130375 (2024).
Ramalho, A. & Miranda, J. C. Tribological characterization of electroless NiP coatings lubricated with biolubricants. Wear 263 (1), 592–597 (2007).
Xia, F., Yan, P., Ma, C. & Liu, Y. Effect of SiC nanoparticles on the structure and properties of Ni + W-SiC nanocoatings. J. Mater. Eng. Perform. 34 (4), 3407–3415 (2025).
Huang, L., Gao, Y., Zheng, Z. J. & Li, H. The influence of Cu on the corrosion resistance of electroless Ni-Cu-P deposits on Al substrate. J. Funct. Mater. 38 (4), 683–687 (2007).
Varathan, E., Chatterji, P., Balaraju, J. N. & Subramanian, S. Autocatalytic duplex Ni-P/Ni-W-P coatings on AZ31B magnesium alloy. Surf. Coat. Technol. 240, 103–109 (2014).
Li, Y., Wang, R., Qi, F. & Wang, C. Preparation, characterization and microwave absorption properties of electroless Ni-Co-P-coated SiC powder. Appl. Surf. Sci. 254 (15), 4708–4715 (2008).
ChouYH et al. Studies on Ni-Mo-P coatings by electroless deposition. Key Eng. Mater. 364-366, 333–339 (2007).
Hui, B., Jian, L. & Wang, L. Electromagnetic shielding wood-based composite from electroless plating corrosion-resistant Ni-Cu-P coatings on Fraxinus mandshurica veneer. Wood Sci. Technol. 48 (5), 961–979 (2014).
Zarebidaki, A. & Akbarpour, M. Corrosion and wear behavior of electroless Ni-P-Cu coatings containing 8 and 18 wt% Cu. Surf. Coat. Technol. 492, 131228 (2024).
Ashassi-Sorkhabi, H., Dolati, H., Parvini-Ahmadi, N. & Manzoori, J. Electroless deposition of Ni-Cu-P alloy and study of the influences of some parameters on the properties of deposits. Appl. Surf. Sci. 185 (3–4), 155–160 (2002).
Marchewka, E. et al. Characterization of electrochemical deposition of copper and copper(I) oxide on the carbon nanotubes coated stainless steel substrates. Sci. Rep. 13 (1), 1–15 (2023).
Liu, Z., Guo, L., Chien, C. L. & Searson, P. C. Formation of a core/shell microstructure in Cu-Ni thin films. J. Electrochem. Soc. 155 (9), D569–D574 (2008).
Turoňová, A., Gálová, M. & Šupicová, M. Parameters influencing the electrodeposition of a Ni-Cu coating on Fe powders. I. Effect of the electrolyte composition and current density. J. Solid State Electrochem. 7 (10), 684–688 (2003).
Liu, Y. & Zhao, Q. Study of electroless Ni-Cu-P coatings and their anti-corrosion properties. Appl. Surf. Sci. 228 (1), 57–62 (2004).
Chi, C. Y. et al. The precipitation strengthening behavior of Cu-rich phase in Nb contained advanced Fe-Cr-Ni type austenitic heat resistant steel for USC power plant application. Progress Nat. Sci. Mater. Int. 22 (3), 175–185 (2012).
Kibria, A. K. M. F. & Tarafdar, S. A. Electrochemical Studies of a nickel-copper electrode for the oxygen evolution reaction (OER). Int. J. Hydrog. Energy. 27 (9), 879–884 (2002).
Shen, Y. F., Xue, W. Y., Liu, Z. Y. & Zuo, L. Nanoscratching deformation and fracture toughness of electroless Ni-P coatings. Surf. Coat. Technol. 205 (2), 632–640 (2010).
Yurdal, K., Karahan, I. H. & Unal, E. Effect of Pulse Current Density Variation on Cu-Zn Alloys Electrodeposited in Pyrophosphate-Based Baths. JOM 77 (10), 7488–7504 (2025).
Unal, E., Yasar, A. & Karahan, I. H. Investigation of the properties of Ni-B alloy nanocomposite coatings reinforced with TiC particles electrodeposited at different current densities. J. Mater. Eng. Perform. 34 (12), 1–20 (2025).
Ozdemir, R., Unal, E. & Karahan, I. H. Effect of Citrate-Based Bath pH on Properties of Electrodeposited Cu-Zn Coating on an Aluminum Substrate. Metall. Mater. Trans. A. 55 (10), 3937–3955 (2024).
He, Y. P. et al. Effects of nanocrystals on hydrogen permeation and diffusion in amorphous electroless Ni-P coatings. Mater. Today Commun. 40, 109499 (2024).
BY Zhou. Comparative study on microstructure and properties of electroless Ni-P and Ni-Cu-P coatings deposited on PEEK. Mater. Prot. 56 (5), 127–132 (2023). (in Chinese).
Hui, B., Li, J., Zhao, Q., Liang, T. & Wang, L. Effect of CuSO4 content in the plating bath on the properties of composites from electroless plating of Ni-Cu-P on birch veneer. Bioresources 9 (2), 2949–2959 (2014).
Ho, C. E., Lin, Y. L. & Kao, C. R. Strong effect of Cu concentration on the reaction between lead-free microelectronic solders and Ni. Chem. Mater. 14 (3), 2663–2672 (2002).
Tian, J., Qi, X. & Xian, G. Effect of hygrothermal aging on the friction behavior and wear mechanism of the multi-filler reinforced epoxy composites for coated steel. J. Mater. Res. Technol. 32, 32140–32151 (2024).
Unal, E., Yasar, A. & Karahan, I. H. Investigation of the Properties of Ni-B/TiC Nanocomposite Coatings Produced at Different Particle Concentrations by Electrodeposition. Metall. Mater. Trans. A. 54 (6), 2340–2361 (2023).
Demir, M., Kanca, E. & Karahan, I. H. Characterization of electrodeposited Ni-Cr/hBN composite coatings. J. Alloys Compd. 844 (1), 7 (2020).
Lima, M. M. et al. Coating fracture toughness determined by Vickers indentation: an important parameter in cavitation erosion resistance of WC-Co thermally sprayed coatings. Surf. Coat. Technol. 177, 489–496 (2004).
Yan, M., Ying, H. G. & Ma, T. Y. Improved microhardness and wear resistance of the as-deposited electroless Ni-P coating. Surf. Coat. Technol. 202 (24), 5909–5913 (2008).
Ma, C. et al. Impact of magnetic field direction on performance and structure of Ni-Co-SiC coatings fabricated via magnetic-field-induced electrodeposition. Coatings 14 (6), 672 (2024).
Cao, M., Yue, Y. & Wang, G. B. Effects of SiC particle concentration on the ultrasonic-assisted jet electrodeposited Ni-SiC nanocoatings. Int. J. Electrochem. Sc. 17 (1), 1–11 (2022).
Afroukhteh, S., Dehghanian, C. & Emamy, M. Preparation of the Ni-P composite coating co-deposited by nano TiC particles and evaluation of it’s corrosion property. Appl. Surf. Sci. 258 (7), 2597–2601 (2012).
Ma, C. et al. Microstructure, wear and corrosion resistances of Ni–ZrO2–CeO2 nanocoatings. Ceram. Int. 50 (12), 20949–20957 (2024).
Acknowledgements
The research is supported by the Heilongjiang Bayi Agricultural University to Introduce Talents (Granted no. XYB202308).
Author information
Authors and Affiliations
Contributions
Qiang Li, Huaxing Li and Qiang Zhang wrote the main manuscript text, Zhenghai Han and Jun Hu prepared Figs. 1, 2, 3, 4, 5, 6, 7, 8, 9, 10, 11, 12 and 13. All authors reviewed the manuscript.
Corresponding author
Ethics declarations
Competing interests
The authors declare no competing interests.
Additional information
Publisher’s note
Springer Nature remains neutral with regard to jurisdictional claims in published maps and institutional affiliations.
Rights and permissions
Open Access This article is licensed under a Creative Commons Attribution-NonCommercial-NoDerivatives 4.0 International License, which permits any non-commercial use, sharing, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if you modified the licensed material. You do not have permission under this licence to share adapted material derived from this article or parts of it. The images or other third party material in this article are included in the article’s Creative Commons licence, unless indicated otherwise in a credit line to the material. If material is not included in the article’s Creative Commons licence and your intended use is not permitted by statutory regulation or exceeds the permitted use, you will need to obtain permission directly from the copyright holder. To view a copy of this licence, visit http://creativecommons.org/licenses/by-nc-nd/4.0/.
About this article
Cite this article
Li, Q., Li, H., Zhang, Q. et al. Influence of CuSO4 concentration on microstructures and properties of electroless deposited Ni/Cu-P coatings. Sci Rep (2026). https://doi.org/10.1038/s41598-026-42256-x
Received:
Accepted:
Published:
DOI: https://doi.org/10.1038/s41598-026-42256-x
